Always refer to the safety information within our service manuals, data sheets and installation guides when handling the turbocharger.

1. Always understand why the original turbocharger needs replacing, determine the cause of any failure and rectify it before fitting a replacement unit.

2. Each Holset turbocharger is designed to match a specific engine and is given a part number and individual serial number. Please ensure the part number shown on your turbocharger dataplate is the correct number for your engine. This is shown in the engine manufacturer's specification listings. The warranty will be invalid if the turbocharger is fitted to the wrong engine.

3. Check that the engine intake/exhaust and aftercooler systems are clean and without obstruction (free from oil, gasket pieces, dust, dirt, carbon or other debris). Replace air filter if necessary, using only OEM recommended parts

4. Check that the oil inlet and oil drain flanges are clean and free from obstruction, internal carbon and sludge (removing to clean if necessary). If in doubt, replace with new.

5. Replace the oil and filter, ensuring that only OEM recommended parts and specified oil are used

7. Mount the turbocharger on the exhaust flange and check that the turbine inlet gasket fits correctly to give a gas tight seal.

8. The orientation of the end housings may need changing in order to align correctly with all other connections. The orientation cannot be altered on Holset HE351CW and all Holset VGTTM. Ensure all fastenings are tightened to the specified torque when the correct attitude is set. See relevant data sheets for further information. In the case of Holset HC5A, HX80/82/83/85 ensure lockplate tabs are secured against the bolt heads.

9. Connect the oil drain pipe then fill the turbocharger oil feed hole with clean engine oil and slowly rotate the rotor by hand

10. Connect all external fittings to the turbocharger. Pull out the fuel stop and crank engine to develop oil pressure.

11. Start the engine and idle checking that all air, gas and oil connections are tight and free from leakage. If necessary tighten any fastenings as appropriate, using soapy water to help detect gas leaks